FDP 1.2000 1 Channel amplifier, 1 x 1200 @ 4ohms or 1 x 2000W @ 2 Ohms

High-powered and will work with almost any system

Focal's FDP 1.2000 mono amplifier can deliver up to 2,000 watts RMS to a subwoofer — providing enough bass to keep up with even the most high-powered audio systems. The FDP 1.2000 uses Class D technology to deliver big-league power from a chassis that's about 2" high.

You can engage the extensive and versatile filter section to optimize the tone and performance for a wide variety of subwoofers and speakers. The variable low-pass filter and adjustable phase focus the bass in your vehicle. An onboard adjustable subharmonic synthesizer allows you to get more bass out of classic recordings. The speaker-level inputs and auto turn-on let you connect this amp to almost any car stereo, even a factory radio.

Remote control, clip light, and bass enhancer

Focal includes a wired remote bass level controller so you can tweak your bass from song to song from your front seat. You'll find subharmonic synthesizer controls on the remote as well. It also features an LED clip light that'll let you know if you're overloading the amp.

For a monster-size setup, get two

For some real loud fun, you can bridge two FDP 1.2000s together to drive a subwoofer system with up to 4,000 watts RMS.

Installation Note: This amplifier's power consumption is beyond the capacity of most automotive electrical systems. To power this amp, your vehicle may require an electrical upgrade that could include a high-output alternator, a Big 3 wiring upgrade, and a second battery.

Product highlights:

• mono subwoofer amplifier
  • 1200 watts RMS x 1 at 4 ohms
  • 2000 watts RMS x 1 at 2 ohms
• CTA-2006 compliant
• Class D amp technology (frequency response: 8-350 Hz)
• variable low-pass filter (40-350 Hz, 24 dB/octave)
• variable subsonic filter: (8-53 Hz, 48 dB/octave)
• variable subharmonic synthesizer (30 and 45 Hz)
• variable phase control (0-180 degrees)

Other Features:

• wired remote level and subharmonic synthesizer control with LED clip light included
• preamp inputs and outputs
• speaker-level inputs (require speaker wire to RCA adapters)
  • auto signal-detection and turn-on with high-level input
• wiring and hardware not included with amplifier
  • 4-gauge power and ground leads recommended
• fuse rating: 25A x 6
• dimensions: 19-5/8"W x 2-3/16"H x 8"D
• warranty: 1 year